Freshly paved and striped parking lot in front of brick townhomes with one blue accessible space

Driveway Paving Experts in Brookhaven Georgia: Asphalt Driveway Installation and New Asphalt Driveway

Affordable Driveway Paving and asphalt driveway installation in Brookhaven, GA and DeKalb County

Brookhaven Asphalt Paving & Repair installs and replaces driveways for homeowners across Brookhaven, GA, where lots are tight and the old pavement often runs right up to a neighbor's fence. The crew covers driveway paving in full, from asphalt driveway installation on cleared ground to a tear-out of a cracked slab. Every new asphalt driveway Brookhaven homeowners order starts with the stone beneath it, so that bed gets the most attention. Water leaves toward the street and the house stays dry.

Why homeowners choose us:

Free written estimates for every paving job
Compacted base under every new surface, not just a layer of asphalt on top
Warrantied work every job backed by a written warranty
Licensed and insured certificate on request

Each job draws on 20+ years on Atlanta pavement and 1,400+ driveways, lots and roads already finished. Nothing gets dug until you have a free written estimate that keeps stone work apart from asphalt and gives the rolled thickness. Warranty paperwork follows the job, and the crew plans around the tight access on many Brookhaven streets.

(678) 252-6324 Get a Free Quote

Get a FREE Asphalt Paving Quote

What Driveway Paving Involves in Brookhaven, GA

Homeowners see a flat black surface, but nearly all of the work happens underneath it. Because the estimate gives each stage its own line, you can read exactly what the price buys and compare it with any other bid you hold:

Layout and grade checks pitch the surface so rainwater exits toward the street, not the garage door.
Tear-out of the old surface breaks up failed asphalt and trucks it off the property.
Subgrade repair digs out soft clay or old fill and replaces it with firm material.
Crushed-stone base is spread in lifts and pressed tight, forming the bed the pavement rests on.
Hot-mix asphalt is spread to the planned thickness and rolled before it cools.
Apron and curb-cut work blends the driveway into the street edge without a lip.
Edge finishing is hand work along the borders that keeps runoff from sneaking beneath.
Driveway resurfacing is offered where the old pavement is still sound enough to take an overlay.

When You Need Driveway Paving in Brookhaven

Most owners wait until the driveway embarrasses them. A better moment is when repairs begin to outnumber good stretches, because patching a failing base only delays the replacement.

Signs Your Brookhaven Driveway Needs Paving

Cracks that return after sealing show that the stone beneath has shifted, and surface fixes will not hold.
A sag or dip near the garage often means the soil underneath has settled and water now collects there.
Ragged edges beside the lawn tell you the shoulder has lost support, so the breakup will keep moving toward the center.
Alligator-pattern cracking across the wheel paths marks a base that can no longer carry the load.
Puddles that linger for a day or more point to a slope problem that new paving can correct.

Why Driveway Paving Is Harder in Brookhaven

Brookhaven sits on rolling Piedmont ground that was built up, regraded and paved over many times. That history creates four problems the crew plans for on every driveway.

Fill and clay under the pavement

Soil maps list Pacolet, Madison, Cecil, Gwinnett and Appling soils, with clay subsoil reaching 30 to 47 percent in Cecil. Much of the built-up city is mapped simply as urban land, so the ground under a driveway may be old fill. Soft spots hide in it, and the crew probes before it commits to a base depth. Where fill proves unreliable, the estimate adds extra stone rather than trusting the ground.

Rain with no off-season

A typical year drops about 50 inches of rain, with no month that stays dry. Fresh asphalt cannot bond to a wet base, so crews wait for dry ground and move the day when a storm approaches. Once built, a properly graded driveway sheds that water instead of storing it, and the base underneath stays firm through every season.

Freezing nights

Freezing nights arrive about 36 times each year. Water in a crack expands as it turns to ice, and the gap grows. A tight, sealed surface over a firm base resists that pressure far better than one with open seams, which is one reason cracks are filled promptly.

Permit paths

The city’s Minor Site Work Permit covers paving replacement and driveway expansion. Expansion counts as new impervious surface, while like-for-like replacement inside the existing footprint is handled with a signed affidavit. The office confirms which path applies before the crew mobilizes.

How Much Does Driveway Paving Cost in Brookhaven, GA?

A new two-car driveway usually costs somewhere from $1,200 up to $4,000. Ripping out a worn one and starting again runs a little higher at the bottom end, from $1,600. Asphalt thickness, stone work, grading and truck access decide where yours falls. Your free written estimate names the exact figure after a visit to the property.

Job	Typical price	Key variables
New driveway, two-car size	$1,200 to $4,000	thickness, base work, grading, access
Driveway repaving	$1,600 to $4,000	removing the old surface, condition of the base
Driveway resurfacing, overlay	$400 to $1,200	condition of the existing surface, overlay thickness
Driveway sealcoating	$281 to $862	size of the driveway, condition, number of coats
Patching and pothole repair	$1,000 to $3,600	number of repairs, depth of the damage

Resurfacing saves real money while the base holds, and the asphalt repair page covers the point where a patch will do. Anyone comparing bids can open the asphalt paving cost page to see what lifts or lowers a price.

Our Driveway Paving Process in Brookhaven, GA

Each driveway moves through the same sequence. Rain, a cold morning or a tight street can shift the dates, and the crew tells you when that happens.

1. Free Estimate and Site Visit

Once you phone in, the estimator drives out, tapes the drive and probes the ground for soft spots. Your free written estimate then shows tear-out, stone, asphalt and apron as separate lines. Questions about access, neighbors or the street edge get answered here, and any concern you raise goes into the plan before work is approved.

2. Removing the Old Surface

Crews break up the failed asphalt and load it onto trucks. Any clay or fill that has turned soft is dug out next. Narrow lots call for smaller machines, and the crew protects fences, mailboxes and plantings along the way. A clean, firm subgrade is the point of this stage, because everything above depends on it.

3. Building the Stone Base

Crushed stone goes in lift by lift, and each lift is pressed firm before the next one is added. The grade is shaped so water drains to the street, and low spots are corrected before any asphalt arrives. Compaction here sets the life of the driveway, which is why the crew refuses to hurry through it.

4. Laying and Rolling the Asphalt

A paver or hand crew spreads hot mix to the thickness in your estimate, and a roller packs it while it is warm. Hand tools close each seam and border. The apron then ties into the street, so the curb cut sits smooth with no lip to catch a tire or a mower. Rolling while the mix is hot is what locks in strength.

5. Cleanup and Cure

The crew sweeps the area, checks the slope for ponding and walks the job with you. Stay off the surface with cars for at least two to three days, and keep heavy trucks off longer. Fresh asphalt stays soft in the heat for a while, so turning the wheel in place can scuff it early on.

Driveway Paving FAQs: Brookhaven, GA

How much does it cost to pave a driveway in Georgia?

For a brand-new two-car drive, the table above gives the range. Redoing one that already exists starts a bit higher. Grading, thickness and base work move the total, and the free written estimate settles the figure for your property.

How much does a 20 by 20 driveway cost to pave?

A pad twenty feet square is a common two-car size, so the first row of the table above covers it. Where it lands in that row turns on the soil and on whether an old surface must come out first.

Can you put new asphalt over old asphalt?

Sometimes, if the driveway below still holds together. A thin overlay then brightens a tired surface for much less money. Over a failed base the fresh layer cracks along the old lines, which is why the crew probes before quoting one.

How long does an asphalt driveway last?

Expect a decent asphalt driveway to serve for fifteen to thirty years, less if it is an overlay. Depth of stone, quality of drainage and regular sealing separate the long-lived ones from the rest.

How thick should an asphalt driveway be?

A typical house gets 3 to 5 inches of asphalt resting on a stone bed of 4 to 8 inches. With any bidder, ask whether the stated depth was measured loose or after the roller.

Is driveway resurfacing worth the money?

Resurfacing pays off when the base underneath is firm and the surface is merely tired. Over a weak base it wastes money, and the first visit makes the difference plain.

Do I need a permit to pave a driveway in Brookhaven?

Brookhaven's Minor Site Work Permit covers paving replacement and driveway expansion, and like-for-like replacement within the same footprint is handled with a signed affidavit. The office confirms which route applies to your property.

Brookhaven Asphalt Paving & Repair serves Brookhaven and DeKalb County.

Get a Free Driveway Paving Quote in Brookhaven, GA

(678) 252-6324 Get a Free Quote